Takaab 4NOT - Quad NOT Gate / Logic Inverter Booster so the red line of

so the red line of the ribbon cable should be at the bottom on both modules

With both the push switches out (ON) a voltage applied to the main input will be outputted with any rises or falls in voltage being slowed down dependent on where the A (attack/rise) and R (release/fall) knobs are set to

1U Intellijel format module

allowing you to easily re-use your VCOs elsewhere in a patch without having to first un-patch the VLH or use a separate mult

Takaab 4NOT - Quad NOT Gate / Logic Inverter Booster so the red line ofThe 4NOT is a simple quad NOT gate logic inverter, used for inverting clock or gate signals. If the signal at IN1 is 0 (or below 1V) then OUT1 will go high (+5V). If the signal at IN1 is high (above 1V) then OUT1 will output 0V. Each output is normalised to the next input. Therefore, without a signal plugged into it's IN an output will always be the opposite state of the output above it. So with 5V only at IN1 you will get 0V at OUTs 1 and 3 and 5V at